C
OMMAND
L
INE
I
NTERFACE
4-164
Default Setting
DHCP address pools are not configured.
Command Mode
Global Configuration
Usage Guidelines
• After executing this command, the switch changes to DHCP Pool
Configuration mode, identified by the (config-dhcp)# prompt.
• From this mode, first configure address pools for the network interfaces
(using the network command). You can also manually bind an address
to a specific client (with the host command) if required. You can
configure up to 8 network address pools, and up to 32 manually bound
host address pools (i.e., listing one host address per pool). However, note
that any address specified in a host command must fall within the range
of a configured network address pool.
Example
Related Commands
network (4-164)
host (4-172)
network
This command configures the subnet number and mask for a DHCP address
pool. Use the no form to remove the subnet number and mask.
Syntax
network network-number [mask]
no network
• network-number - The IP address of the DHCP address pool.
• mask - The bit combination that identifies the network (or subnet) and
the host portion of the DHCP address pool.
Console(config)#ip dhcp pool R&D
Console(config-dhcp)#