C-4 Sun Fire X2250 Server Service Manual • April 2009
4. Repeat Steps 1 through 3 to install the remaining mounting bracket on the other
side of the server.
C.3 Attaching the Slide-Rail Assemblies to
the Rack
Use this procedure to install the slide-rail assemblies to the rack.
1. Position a slide-rail assembly in your rack so that the brackets at each end of the
slide-rail assembly are on the outside of the front and rear rack posts. (See
FIGURE C-3.)
2. Attach the slide-rail assembly to the rack posts, but do not tighten the screws
completely.
The method used to attach the slide rails varies, depending on the type of rack:
■ If your rack has threaded mounting holes in the rack posts, first determine
whether the threads are metric or standard, then insert the correct mounting
screws through the slide-rail brackets and into the threaded holes.
■ If your rack does not have threaded mounting holes, insert the mounting screws
through both the slide-rail brackets and rack posts, then secure them with the
caged nuts.