Filter
Top Products
4-10 Sun Fire X2250 Server Service Manual • April 2009
Note – The examples shown in these procedures use the x8 card, but the installation
and removal instructions are the same for the x16 card. The x16 riser assembly has
one PCIe card connector, rather than two.
4.5.2.1 Removing the Riser Assembly and PCIe Card
To remove the riser assembly and PCIe card:
1. Power off the system and remove the cover as described in Section 4.3,
“Powering Off the Server and Removing the Cover” on page 4-3.
FIGURE 4-6 Removing the PCIe Card Riser Assembly
2. Placing your fingers on the two green areas on the riser assembly, pull the
assembly upward and out of the chassis. See
FIGURE 4-6.
3. Unlatch the PCIe card and remove the card from the PCIe card riser assembly
connector. See
FIGURE 4-7.