Appendix C Installing the Server Into a Rack With Optional Slide Rails C-7
8. If available, extend the anti-tilt bar at the bottom of the rack. (See FIGURE C-5.)
FIGURE C-5 Extending the Anti-tilt Bar
Caution – If your rack does not have an anti-tilt bar, there is some danger of the rack
tipping.
C.4 Installing the Server Into the Slide-Rail
Assemblies
Use this procedure to install the server chassis, with mounting brackets, into the
slide-rail assemblies that are mounted to the rack.
Caution – This procedure requires a minimum of two people because of the weight
of the server. Attempting this procedure alone could result in equipment damage or
personal injury.
Caution – Always load equipment into a rack from the bottom up so that it will not
become top-heavy and tip over. Deploy your rack’s anti-tilt bar to prevent the rack
from tipping during equipment installation.