Filter
Top Products
4-4 Service Manual
Removal procedures
CAUTION: Remove the power cord from the printer or wall outlet before you connect or
disconnect any cable or electronic board or assembly for personal safety and to prevent damage
to the printer.
CAUTION: Use the handholds on the side of the printer. Make sure your fingers are not under the printer when
you lift or set the printer down.
Note: Some removal procedures require removing cable ties. You must replace cable ties during reassembly to
avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
Covers removals
Fuser wiper cover assembly removal
1.
Squeeze the two latches together, and pull up.
2. Remove the fuser wiper cover assembly.