Filter
Top Products
Diagnostic information 2-47
201 .12 Page did not reach exit
sensor. Fuser page
count between 100,000
and 199,999.
• Page jammed on fuser input guide.
• Page did not enter or exit fuser nip
cleanly.
• Exit sensor not functioning correctly.
• Check fuser entry guide for
toner build up.
• Check fuser for wear or
contamination. if a problem
is found, replace the fuser
assembly. See “Fuser
assembly removal” on
page 4-26.
• The fuser exit sensor may
not be functioning correctly.
Go to “Fuser exit sensor
service check” on
page 2-92.
201 .14 Expected wide page not
detected by narrow
media sensor, possible
accordion jam. Fuser
page count between
100,000 and 199,999.
• Page did not enter or exit fuser nip
cleanly.
• Narrow media sensor not functioning
correctly.
• Actual page is narrow when wide
page was expected.
• If label media, ensure front
edge meets 1/8 inch
requirement.
• Check fuser for wear or
contamination. If a problem
is found, replace the fuser
assembly. See “Fuser
assembly removal” on
page 4-26.
• If media is narrow, then turn
off first sheet detection
(engine settings 3 = 16). In
Diagnostics mode, select
PRINTER SETUP and
Engine Setting 3.
• The fuser narrow media
sensor may not be
operating properly. Go to
“Fuser narrow media
sensor service check” on
page 2-93.
201 .20 Page did not reach exit
sensor. Fuser page
count between 200,000
and 299,999.
• Page jammed on fuser input guide.
• Page did not enter or exit fuser nip
cleanly.
• Exit sensor not functioning correctly.
• Check fuser entry guide for
toner build up.
• Check fuser for wear or
contamination. If a problem
is found, replace the fuser
assembly. See “Fuser
assembly removal” on
page 4-26.
• The fuser exit sensor may
not be functioning properly.
Go to “Fuser exit sensor
service check” on
page 2-92.
201 .21 Main drive motor
identification failed.
Fuser page count
between 200,000 and
299,999.
Main drive motor not working. Check motor connections to
motor and system board. If no
problem is found, go to “Main
drive service check” on
page 2-105
.
User attendance messages—paper jams and paper handling errors (2xx.xx)
Error
code
Sub
codes
Description Possible causes Action