Filter
Top Products
2-42 Service Manual
59 .xx Incompatible Tray x An incompatible tray is installed. For Tray x, x= 2, 3, 4, or 5.
Remove the incompatible tray and press to clear the message.
Note: If the user installed the incompatible device to satisfy a Check Device
Connections/reattach message, the user should reinstall an associated
compatible option or hot unplug the option.
59 .xx Incompatible Duplex An incompatible duplex option is installed.
Remove the incompatible duplex option and press to clear the message.
Note: If the user installed the incompatible device to satisfy a Check Device
Connections/reattach message, the user should reinstall an associated
compatible option or hot unplug the option.
59 .xx Defective Disk This error code displays when the printer detects a defective disk. This error
may occur at power on or during disk format and write operations. While this
message displays, press to clear the message. The disk is marked
defective and normal printer operations continue. Disk operations are not
allowed with a defective disk. The Format Disk menu is not shown.
62 .xx Disk Full This error code displays when there is not enough free space on the disk to
hold the resources that have been requested to be written to the disk. This
message displays for both resource and PostScript Disk operators when the
disk is full.
63 .xx Unformatted Disk This error code displays when the printer detects an unformatted disk at
power on. Press to clear the message. The disk is marked as bad and
normal operation continues. Disk operations are not allowed until the disk is
formatted.
64 .xx Unsupported Disk
Format
The printer detects an unsupported disk format at POR.
Press to clear the message. The disk is marked as bad and normal
operation continues. Further disk operations are not allowed until the disk is
formatted.
80 .xx Scheduled Maintenance The operator panel displays this message at each 300K page count interval.
It is necessary to replace the fuser assembly, transfer roller, charge roll, and
pick rolls at this interval to maintain the print quality and reliability of the
printer. The parts are available as a maintenance kit. For more information,
go to “Scheduled maintenance” on page 6-1.
81 .xx Engine Code CRC
Failure
This error displays when the microcode to be programmed in the engine
flash code module has failed a CRC check. Press to clear the message.
The microcode data is discarded and must be re-transmitted from the host
computer.
.88 .xx Toner Low This message displays when toner low occurs and the toner low alarm is
activated. Press to clear this message.
1565 .xx Emul Error
Load Emul Option
This message appears when the IPDS emulation version contained in the
SIMM does not function with the printer code. This message automatically
clears in 30 seconds, and the IPDS emulation is disabled. No other printer
functions are affected. The correct IPDS emulation must be downloaded.
User attendance messages (continued)
Error
code
Sub
code
Primary message Description/action