Filter
Top Products
2-36 Service Manual
Install Env Feed
or Cancel Job
This message is displayed when the envelope feeder has been hot
unplugged. The printer requires the reinstallation of the feeder to print a
page which has been formatted by the interpreter before the feeder was
removed.
The following actions may be taken:
• Install the envelope feeder.
• Press until Busy/Waiting displays. Select one of the following:
-Cancel Job
- Reset Printer
- Reset Active Bin
If the message cannot be cleared, go to “Envelope feeder service check”
on page 2-84.
Install Tray x
or Cancel Job
Tray x=Tray 2, Tray 3, Tray 4, Tray 5.
This message is displayed when a paper handling option has been hot
unplugged. The printer requires the reinstallation of the option to print a page
which has been formatted by the interpreter before the option was removed.
The following actions may be taken:
• Install the option.
• Press until Busy/Waiting displays. Select one of the following:
-Cancel Job
- Reset Printer
- Reset Active Bin
If the message cannot be cleared, go to “Input tray(s) service check” on
page 2-102.
Load Staples This message displays when the Staples Empty Alarm is activated and one
of the following occurs:
• There are no staples in the stapler.
• The maximum number of staples have been fired after the engine has
reported that the staple cartridge is low.
• The printer does not detect the staple cartridge is present.
The following actions may be taken:
• Install a new staple cartridge to clear this message and select Start or
Continue to resume printing the staple job.
• Choose to ignore the Load Staples message for this print job by pressing
. The printer starts or resumes printing, but does not staple the rest of
the job.
• Press until Busy/Waiting displays. The following actions may be
available:
-Cancel Job
- Reset Printer
- Reset Active Bin
Priming Failed
Retry. Go/Stop?
This message displays when an error has occurred during the staple priming
operation. This message not only notifies the user that a specific error
interfered with the priming, but allows the user to request the process begin
again.
The following actions are available:
• Press to restart the priming operation.
• Press or to cancel the priming operation.
User attendance messages (continued)
Error
code
Sub
code
Primary message Description/action