Filter
Top Products
Section 1 Installing the Hardware
PocketPro 100S Administrator’s Guide -- Document #40165-110 Rev. A 1-4
LED Indicators
Test Switch
Options
The back edge of the PocketPro 100S provides LED (Light Emitting Diodes) indicators for easy monitoring. The
following table defines the function of each LED.
The back edge of the TROY print server provides LED indicators (Light Emitting Diodes) for easy monitoring.
The following table defines the function of each LED.
To print a self-test page, press and hold the Test switch for one-eighth of a second but less than five seconds.
To reset the unit back to factory default settings, press and hold the Test switch for at least five seconds, and
then power-cycle the unit.
Label Color State Status
ON
The unit is receiving power.
POWER
O
RANGE
OFF
The unit is not receiving power.
ON
The unit is transmitting at 100 megabits per second.
DATA
G
REEN
OFF
The unit is transmitting at 10 megabits per second.
ON
There is an Ethernet link.
OFF
There is no Ethernet link.
LINK
Y
ELLOW
Blinking
There is network activity.
DATA+LINK YELLOW
GREEN
Blinking
Alternately
A fatal error or exception has occurred.
DATA+LINK YELLOW
GREEN
Blinking
Simultaneously
The firmware is being updated.