TROY Group 100S Printer User Manual


 
Section 4 Novell NetWare Network Configuration
PocketPro 100S Administrator’s Guide -- Document #40165-110 Rev. A 4-24
Adding NetWare
Print Queues in
Queue Server
Mode Using
NWAdmin
If you are using WebXAdmin or JetAdmin 1.xx or 2.xx, you need to use NWAdmin to configure the actual
NetWare print queue. This is because these utilities only allow you to define the print server context and tree (or
file server, if you are using bindery mode). The following steps are required:
1. Make sure that you have defined the context and tree for each NetWare Print Server and Printer that you
wish to configure by using WebXAdmin, or the print server console as described in previous sections. Then
start the Novell NWAdmin program by double clicking on the icon.
2. Create a printer object:
Click on the container where the object will reside.
Select Object from the menu bar, and then select Create.
When you get the New Object menu, select Printer (non-NDPS), and then click on OK.
Enter a printer name, and then click on Create. The new printer will then be listed.
If you are configuring the port, you may enter any arbitrary name for the Printer.
NOTE
: If you are configuring the default service, the name of the printer object can be any unique name (it cannot
be the same as the default service name). If you are configuring any other service, the name of the printer object
is the same as the name of the service.
3. Create a print queue object:
Click on the container where the object will reside. Select Object from the menu bar and then Create.
When you get the New Object menu, select Print Queue, and then click on OK.
Select Directory Service Queue. Enter any desired name for the print queue.
Click on the Print Queue Volume button, and select the volume on which the print queue will reside.
Click on OK, and then click on Create.