Section 3 TCP/IP Network Configuration
PocketPro 100S Administrator’s Guide -- Document #40165-110 Rev. A 3-7
SCO UNIX
Configuration
SCO UNIX requires TCP/IP V1.2 or later to work with the TROY PocketPro 100S. You must first configure the
/etc/hosts file as described in step 2. If necessary, start lpr services with the mkdev rlp command (this
command must be executed only one time or serious problems may result!). Then issue the rlpconf command
at the SCO system prompt. Respond to the questions as follows:
Printer name. Enter the name of the print server service (usually BINARY_P1 for binary graphics files or
TEXT_P1 for ASCII text files). If you are configuring more than one TROY print server, you will need
to change the print server service name on each print server to a unique name (using the WebXAdmin
Configure Service facility or the SET SERVICE oldname NAME newname command; refer to Appendix
A and Appendix B for details), because the service name is also used as the name of the print queue.
Remote printer or a local printer: Enter "r" for remote
Name of the remote host that <Printer name> is attached to: Enter the name of the TROY print server
that you configured in the /etc/hosts file)
System default printer: Enter either "y or "n" to make the printer the system default printer.
You should now be able to print to your queue. Note that this procedure assigns the queue name as the same as
the name of the print server's service. If you want to name the queue something different than the service name,
edit the /etc/printcap file.