TROY Group 100S Printer User Manual


 
Section 3 TCP/IP Network Configuration
PocketPro 100S Administrator’s Guide -- Document #40165-110 Rev. A 3-11
Using
ExtendView to
Assign an IP
Address
Using DHCP to
Configure the
Print Server IP
Address
To assign an IP address using ExtendView, perform the following steps:
1. Launch the ExtendView utility by clicking on Start, Programs, TROY Group Printing, and ExtendView.
The utility will automatically search for TROY wireless devices on the network.
2. Locate your PocketPro 100S from the list of discovered devices; it will be listed as TWC_XXXXXX (where
XXXXXX are the last six digits of the MAC address with an IP address of 192.0.0.192).
3. Double-click on your PocketPro 100S from the list of displayed devices. ExtendView will prompt you for an
IP address. Enter an IP address, and then click on OK. You will then be directed to the Print Server
Configuration page.
4. Click on the TCP/IP tab, enter the subnet mask and default gateway, and then click on OK.
5. When prompted, click on Yes to save these changes and reset the print server.
The TROY PocketPro 100S supports the DHCP protocol for automatically loading the IP address from a host
computer that supports DHCP. By default, the print server will automatically try DHCP, BOOTP, and rarp
before using the IP address configured in the server.
NOTE: This procedure may take about a minute, so the print server cannot be accessed via TCP/IP during that
time. If a faster IP address load is required, select the desired IP configuration method (AUTO, DHCP, BOOTP,
RARP, STATIC) via WebXAdmin, or the print server console SET IP METHOD command (STATIC is used when the
IP address is manually entered).