Filter
Top Products
Section 3 TCP/IP Network Configuration
PocketPro 100S Administrator’s Guide -- Document #40165-110 Rev. A 3-15
Configuring the
Print Server IP
Address with
XCONFIG
Users of Novell computers have additional alternatives for configuring the TROY PocketPro 100S IP address by
using the remote console facility.
On a NetWare system, you would use the XCONFIG utility included with every TROY print server. Simply type
XCONFIG at the DOS prompt and select the desired TROY print server.
1. If you are using the remote console, you will get the message Connection established (XCONFIG) or Remote
console reserved (ULTRIX). Press RETURN and enter the password ACCESS in response to the "#" prompt
(it will not echo).
2. You will be prompted for a user name. Enter anything in response to this prompt.
3. You will then get the Local> prompt. Type SET IP ADDRESS ipaddress, where ipaddress is the desired IP
address you wish to assign to the TROY print server (check with your network manager for the IP address to
use). For example:
Local> SET IP ADDRESS 192.189.207.3
4. You will now need to set the subnet mask by typing SET IP SUBNET subnetmask, where subnetmask is the
desired subnet mask you wish to assign to the TROY print server (check with your network manager for the
subnet mask to use). For example:
Local> SET IP SUBNET 255.255.255.0
5. If you do not have any subnets, use one of the following default subnet masks:
255.255.255.0 for class C networks
255.255.0.0 for class B networks
255.0.0.0 for class A networks
6. Your network type can be identified by the left-most group of digits in your IP address. The value of this
group ranges from 192 through 255 for Class C networks (e.g., 192.189.207.3), 128 through 191 for Class B
networks (e.g., 128.10.1.30), and 1 through 127 for Class A networks (e.g., 13.27.7.1).