5-42 Operator Guide
Troubleshooting
Perform IPL on the tape drive again, using one of the following
procedure:
1. Turn off the tape drive by pressing the Power switch to OFF.
2. Wait 10 seconds and power the tape drive on by pressing the
Power switch to ON.
Figure 5-31 Power on tape drive
3. For the 36-track drive, press and hold the Select, Scroll, and
Ready buttons for at least five seconds.
Figure 5-32 Press and hold Select, Scroll and Ready buttons
1. Select button
2. Scroll button
3. Ready button
If the Initial Program Load procedure fails again, note the error
code and time, then call for service.
Solving other cartridge tape drive problems
Other problems that may occur with the 36-track cartridge tape
drive include the following.