Xerox 180 EPS Printer User Manual


 
3-4 Operator Guide
Managing the system
4. Click [Yes] on the confirmation window.
5. When the DocuSP Print Services window closes and an ok
prompt appears at the bottom of the screen, enter boot.
6. When the DocuSP Print Services window reopens, release all
held queues. (Refer to “Releasing queues,” earlier in this
chapter.)
Restarting the DocuSP software
1. On the DocuSP Print Services window, log on as
Administrator or Operator.
2. Hold any active queues. (Refer to “Holding queues,” earlier in
this chapter.)
3. On the DocuSP Print Services window, select [Restart] from
the System menu.
4. Wait for the DocuSP Print Services window to close and
reopen.
5. Release all held queues. (Refer to “Releasing queues,” earlier
in this chapter.)
Powering off the system
You may be required to power down the system under the
following conditions:
Work is being done on an attached printer.
The Sun workstation is being moved.
SCSI peripherals are being added or removed.
A power outage is planned.
The Sun workstation is receiving hardware maintenance.
The DocuSP controller will not be in use for an extended
period.
The Sun workstation should run continuously. Refer to the Sun
hardware manuals for recommendations for when to power off the
system.
CAUTION: Do not shut down DVD players and SCSI tape drives
unless you are powering off the entire system.
1. Log on as Administrator or Operator.
2. Hold any active queues. (Refer to “Holding queues,” earlier in
this chapter.)
3. Select [Printer Off] from the Printer menu.
4. Select [Shutdown] from the System menu.