Xerox 180 EPS Printer User Manual


 
1-12 Operator Guide
Overview
Figure 1-5 Feeder tray control panel
1. Ready to Open indicator on feeder trays
2. Please Wait indicator on feeder trays
3. Tray Unlock button (feeder)
4. Paper Level indicators on feeder trays
Ready to Open
indicator on
feeder trays
Glows green when the tray can be pulled out and paper can be
added to it.
Please Wait
indicator on
feeder trays
Shows that the tray is in motion. This indicator is lit red when the
Tray Unlock button is pressed, while the tray is lowering, and while
the tray is rising. The indicator goes off when the tray elevator
reaches its destination.
Tray Unlock button
(feeder)
Enables the feeder tray to be opened.
If the tray is in use when this button is pressed, the feed
selection switches to the backup tray if one has been
identified. Otherwise, printing stops.
If the tray is in use and selected as a backup tray, pressing the
Tray Unlock button causes the tray elevator to lower and the
tray to be unavailable for auto switching.
If the tray elevator is in the raised position and the tray is not in
use or selected as a backup tray, pressing this button causes
the elevator to lower with no effect on printing operations.
This button functions when the Please Wait indicator is off.
Paper Level
indicators on
feeder trays
Display the approximate quantity of paper in the tray. Each display
shows paper by quarter reams up to one ream, and then by full
reams. The green indicator appears above its Paper Level
indicator.
Stacker bins
Each output stacker bin has offsetting capability and a capacity of
2500 sheets of 20 pound or 80 gsm paper.
NOTE: This capacity does not apply to 11 by 17 inch and A3
papers. Because of the additional weight these large sheets add
to the bins, each bin is restricted to hold only up to 1500 sheets of
A3 or 11 by 17 inch papers, for safety reasons.