5-44 Operator Guide
Troubleshooting
Figure 5-34 AC power switch
3. Turn the DC power switch OFF(0) and then ON (1).
Figure 5-35 DC power switch
4. If the display is still blank, call for service.
• Problem: The tape drive does not go into a Ready state.
1. Determine if the tape drive is online by pressing the Scroll
button until the message display shows the Status
display.
2. If the tape drive is offline, refer to the section, “Placing the
tape drive online” in the “Managing the system” chapter.
3. If the tape drive still is not ready, the cartridge may be
inserted incorrectly. Remove the cartridge from the
transport and insert it again.