3Com 10014298 Switch User Manual


 
168 CHAPTER 7: QOS/ OPERATION
For output and description of the related commands, see the Switch 7750
Command Reference Guide.
QoS Configuration
Examples
This section provides the following configuration examples:
Traffic Limit and Line Rate
Port Mirroring
Priority Relabeling Configuration Example
Packet Redirection
Queue Scheduling
RED
Traffic Bandwidth
Traffic Statistics
Traffic Limit and Line Rate
In this example, the intranet is connected through 100M ports between
departments, and the wage server is connected through the port
GigabitEthernet7/0/1 (subnet address 129.110.1.2). For the wage server, the
inbound traffic is limited to 20M and the outbound traffic to 20M, on average.
Those packets exceeding the threshold are labeled with priority level 4.
Only the 20-Port 10/100/1000BASE-T and 20-Port 1000BASE-X-SFP I/O modules
support further processing for excessive traffic.
Only the 20-Port 10/100/1000BASE-T and 20-Port 1000BASE-X-SFP I/O modules
support line rate setting.
For the 20-Port 10/100/1000BASE-T and 20-Port 1000BASE-X-SFP I/O modules,
the adjustment step for both traffic limit and line rate is 1 Mbps, but for other
interface units, the adjustment step for traffic limit is 64 Kbps.
Display the settings of priority used for putting
the packet to the sending queue
display priority-trust
Clear the statistics information reset traffic-statistic { inbound | outbound } {
all | ip-group { acl-number | acl-name } [ rule
rule ] | link-group { acl-number | acl-name } [
rule rule ] }
Table 184 Display and Debug QoS
Operation Command