Filter
Top Products
SNMP 265
Configure the info-center loghost as follows:
1 Enable the logging system.
[SW7750]info-center enable
2 Set the host at 202.38.1.10 as info-center loghost, sets the severity threshold to
informational, the output language to English and allows the RSTP and IP modules
to output information.
[SW7750]info-center loghost 202.38.1.10 language english
[SW7750]info-center source rstp channel 5 log level informational
[SW7750]info-center source ip channel 4 log level informational
For the configurations at the host side, see “Configuring the Info-center Loghost”
on page 264.
Displaying and Debugging the Syslog Function
After performing the syslog configuration, execute the display command in all
views to display the configuration and to verify the effect of the configuration.
Execute the
reset command in user view to clear the statistics of the syslog
module. Execute the
debugging command in user view to debug the syslog
module.
Perform the following configuration in system view.
SNMP The Simple Network Management Protocol (SNMP) is used for transmitting
management information between any two nodes. In this way, network
administrators can easily search and modify the information on any node on the
network. They can also locate faults promptly and implement the fault diagnosis,
capacity planning, and report generating. SNMP adopts the polling mechanism
and provides the most basic function set. It is most applicable to the small-sized,
fast-speed, and low-cost environment. It only requires the unverified transport
layer protocol UDP, and is widely supported by many other products.
Table 297 Displaying and Debugging the Syslog Function
Operation Command
View details about the information channel display channel [ channel-number
| channel-name ]
View the configuration of the system log and
the information recorded in the memory
buffer
display info-center
Reset the information in the log buffer reset logbuffer
Reset the information in the trap buffer reset trapbuffer
Enable terminal log information display terminal logging
Disable terminal log information display undo terminal logging
Enable the log debugging/log/trap on the
terminal monitor
terminal monitor
Disable the log debugging/log/trap on the
terminal monitor
undo terminal monitor
Enable terminal trap information display terminal trapping
Disable terminal trap information display undo terminal trapping