Filter
Top Products
174 CHAPTER 7: QOS/ OPERATION
The 20-Port 10/100/1000BASE-T and 20-Port 1000BASE-X-SFP I/O modules do not
support this configuration.
Figure 46 Traffic Bandwidth
To create this configuration:
1 Define the time range 8:00 to 18:00.
[SW7750]time-range 3com 8:00 to 18:00 daily
2 Define traffic rules for the packets of IP addresses 1.0.0.1 and 2.0.0.1.
[SW7750]acl number 2000
[SW7750-acl-basic-2000]rule 0 permit ip source 1.0.0.1 0.0.0.0
time-range 3com
[SW7750-acl-basic-2000]rule 1 permit ip source 2.0.0.1 0.0.0.0
time-range 3com
3 Configure traffic bandwidth for the packets of IP addresses 1.0.0.1 and 2.0.0.1,
view the configuration with the display command.
Enter QoS view.
[SW7750-Ethernet3/0/8]qos
[SW7750-qoss-Ethernet3/0/8]
Configure traffic bandwidth for the packets of IP addresses 1.0.0.1 and 2.0.0.1,
view the configuration with the display command.
[SW7750-qoss-Ethernet3/0/8]traffic-bandwidth outbound ip-group 1
rule 0 20 60 40
[SW7750-qoss-Ethernet3/0/8]traffic-bandwidth outbound ip-group 1
rule 1 40 60 60
[SW7750]display qos-interface Ethernet3/0/8 traffic-bandwidth
Traffic Statistics
In this example, the IP address of the PC1 is 1.0.0.1 and the address of PC2 is
2.0.0.2. The switch is uplinked through the port GE7/0/8. Count the packets sent
between 8:00 and 18:00 each day from the switch to PC1.
E3/0/8
GE3/0/1
GE3/0/2
VLAN2,
1.0.0.1/8
VLAN3,
2.0.0.1/8