Filter
Top Products
234 CHAPTER 9: AAA AND RADIUS OPERATION
Perform the following configuration in HWTACACS view.
Table 2-41 Configuring stop-accounting packet retransmission
OperationCommand
Enable stop-accounting packet retransmission and set the allowed maximum
number of transmission attemptsretry stop-accounting retry-times
Disable stop-accounting packet retransmissionundo retry stop-accounting
Clear the stop-accounting request packets that have no responsereset
stop-accounting-buffer hwtacacs-scheme hwtacacs-scheme-name
By default, stop-accounting packet retransmission is enabled, and the maximum
number of transmission attempts is 300.
2.4.6 Configuring Source Address for HWTACACS Packets Sent by NAS
Perform the following configuration in the corresponding view.
Table 2-42 Configuring source address for HWTACACS packets sent by the NAS
OperationCommand
Configure the source address for HWTACACS packets sent from the NAS
(HWTACACS view).nas-ip ip-address
Delete the configured source address for HWTACACS packets sent from the NAS
(HWTACACS view).undo nas-ip
Configure the source address for HWTACACS packets sent from the NAS (System
view).hwtacacs nas-ip ip-address
Cancel the configured source address for HWTACACS packets sent from the NAS
(System view).undo hwtacacs nas-ip
The HWTACACS view takes precedence over the system view when configuring
the source address for HWTACACS packets sent from the NAS.
By default, the source address is not specified, and the interface address for packet
sending is used as the source address.
2.4.7 Setting a Key for Securing the Communication with TACACS Server
When using a TACACS server as an AAA server, you can set a key to improve the
communication security between the switch and the TACACS server.
Perform the following configuration in HWTACACS view.