220 CHAPTER 9: AAA AND RADIUS OPERATION
Disconnecting a User by Force
Sometimes it is necessary to disconnect a user or a category of users by force. The
system provides the following command to serve this purpose.
Perform the following configurations in system view.
By default, no online user will be disconnected by force.
Configuring the
RADIUS Protocol
On the Switch 7750, the RADIUS protocol is configured per RADIUS server group
basis. In a real networking environment, a RADIUS server group can be an
independent RADIUS server or a set of primary/secondary RADIUS servers with the
same configuration but two different IP addresses. Attributes of every RADIUS
server group include IP addresses of primary and secondary servers, shared key and
RADIUS server type, etc.
RADIUS protocol configuration only defines some necessary parameters using
information for interaction between NAS and RADIUS Server. To make these
parameters effective, it is necessary to configure, in the view, an ISP domain to use
Remove the password set for the specified
user
undo password
Set the state of the specified user state { active | block }
Disable the state of the specified user undo state { active | block }
Set a service type for the specified user service-type { ftp [
ftp-directory directory ] |
lan-access |[ level level |
telnet [ level level ] ] | telnet
[ level level |[ level level ] ] }
Cancel the service type of the specified user undo service-type { telnet [
level |[ level ] ] | ftp
[ftp-directory] | lan-access | [
level | telnet [ level ] ] }
Configure the attributes of lan-access users attribute { ip ip-address | mac
mac-address | idle-cut second |
access-limit max-user-number |
vlan vlanid | location { nas-ip
ip-address port portnum | port
portnum }*
Remove the attributes defined for the
lan-access users
undo attribute { ip | mac | idle-cut
| access-limit | vlan | location
}
Table 234 Disconnect a User by Force
Operation Command
Disconnect a user by force cut connection { all |
access-type { dot1x | gcm } |
domain domain-name | interface
portnum | ip ip-address | mac
mac-address | radius-scheme
radius-scheme-name | vlan vlanid
| ucibindex ucib-index |
user-name user-name }
Table 233 Set/Remove the Attributes Concerned with a Specified User
Operation Command