3Com 10014298 Switch User Manual


 
36 CHAPTER 2: PORT CONFIGURATION
Setting Flow Control for Ethernet Port
Permitting/Forbidding Jumbo Frames on the Ethernet port
Setting Ethernet Port Broadcast Suppression Ratio
Setting the Link Type for an Ethernet Port
Adding the Ethernet Port to a VLAN
Setting the Default VLAN ID for Ethernet Port
Copying a Port Configuration to Other Ports
Displaying and Debugging Ethernet Ports
Entering Ethernet Port View
Before configuring the Ethernet port, enter Ethernet port view.
Perform the following configuration in system view.
The submodule on the fabric for the 4-slot chassis is always set to 1.
Enabling and Disabling Ethernet Ports
The following command can be used for disabling or enabling the port. After
configuring the related parameters and protocol of the port, you can use the
following command to enable the port.
Perform the following configuration in Ethernet port view.
By default, the port is enabled.
Setting Description Character String for Ethernet Port
You can use the following command to identify the Ethernet ports.
Perform the following configuration in Ethernet port view.
By default, the port description is a null character string.
Table 25 Enter Ethernet Port View
Operation Command
Enter Ethernet port view interface {Gigabit | Ethernet}
slot/subslot/port
Table 26 Enable/Disable an Ethernet Port
Operation Command
Disable an Ethernet port shutdown
Enable an Ethernet port undo shutdown
Table 27 Set Description Character String for Ethernet Port
Operation Command
Set description character string for Ethernet
port.
description text
Delete the description character string of
Ethernet.
undo description