254 CHAPTER 11: SYSTEM MANAGEMENT
Configuring the Managing Devices is described in the following sections:
■ Designating the APP for the Next Boot
■ Displaying Devices
Designating the APP for
the Next Boot
In the case that there are several operational images in the flash memory, you can
use this command to designate the operational file (*.app) to use when the Switch
7750 is booted.
Perform the following configuration in user view.
Tasks for designating the APP for the next boot are described in the following
sections:
■ Upgrading BootROM
■ Resetting a Slot
■ Setting the Slot Temperature Limit
■ Setting the Backboard View
Upgrading BootROM
You can use this command to upgrade the BootROM with the BootROM program
in the flash memory. This configuration task facilitates the remote upgrade. You
can upload the BootROM program file, from a remote end to the switch, by FTP
and then use this command to upgrade the BootROM on the modules.
Perform the following configuration in user view.
Resetting a Slot
The Switch 7750 allows the administrator to reset a slot in the system.
Perform the following configuration in user view.
The parameter slot-num ranges from 0 to 6. Setting the parameter to 0 resets the
fabric module, taking the same effect as resetting the entire system. Setting the
parameter from 1 through 6 resets the I/O modules in the corresponding slots.
If you input reboot only, the whole system will be reset.
Table 276 Designating the APP for the next boot
Operation Command
Designate the APP for the next boot boot bootloader file-url
Table 277 Upgrading BootROM
Operation Command
Upgrade BootROM boot BootROM file-url
Table 278 Resetting a Slot
Operation Command
Reset a slot reboot [ slot slot-num ]