Filter
Top Products
Configuring ACL Control 177
Figure 48 Control TELNET User With ACL
Use the following commands to control TELNET users with ACL.
1 Define the basic ACLs.
[SW7750]acl number 2000 match-order config
[SW7750-acl-basic-2000]rule 1 permit source 10.110.100.52 0
[SW7750-acl-basic-2000]rule 2 permit source 10.110.100.46 0
[SW7750-acl-basic-2000]quit
2 Call an ACL.
[SW7750]user-interface vty 0 4
[SW7750-user-interface-vty0-4]acl 2000 inbound
Configuring ACL Control
for SNMP Users
The Switch 7750 supports remote management with the network management
software. The network management users can access the switch with SNMP.
Controlling such users with an ACL can filter the illegal network management
users, and prevent them from accessing the local switch.
The steps to control SNMP users with ACL are described in the following sections:
■ Defining an ACL
■ Importing an ACL to Control SNMP Users
Defining an ACL
To implement the ACL control function, you can only call the numbered basic ACL,
ranging from 2000 to 2999. Use the configuration commands introduced in
“Configuring ACL Control for TELNET Users”.
Importing an ACL to Control SNMP Users
To control network management users with an ACL, import the defined ACL when
configuring the SNMP community name, username, and group name.
Perform the following configuration in system view.
Internet
Switch
Table 188 Define a Numbered Basic ACL
Operation Command
Import an ACL when configuring the SNMP
community name
snmp-agent community { read | write }
community-name [ [ mib-view view-name ] | [
acl acl-number ] ]*