3Com 10014298 Switch User Manual


 
Configuring GARP/GVRP 63
Note that the value of the join timer should be no less than twice the value of the
hold timer, and the value of the leave timer should be greater than twice the value
of the join timer and smaller than the leaveall timer value. Otherwise, the system
displays an error message.
Join timer > 2 x hold timer
Leave timer > 2 x join timer AND < leavall timer
GARP timers have the following default values:
Hold timer — 10 centiseconds
Join timer — 20 centiseconds,
Leave timer — 60 centiseconds
Leaveall timer — 1000 centiseconds.
Displaying and Debugging GARP
After you configure the GARP timer, execute the display command in all views to
display the GARP configuration, and to verify the effect of the configuration.
Execute the reset command in user view to reset the GARP configuration.
Execute the debugging command in user view to debug the GARP configuration.
Configuring GVRP GARP VLAN Registration Protocol (GVRP) is a GARP application. GVRP is based on
the GARP, and maintains the dynamic VLAN registration information in the switch
and distributes the information to other switches. All the GVRP-supporting
switches can receive VLAN registration information from other switches and can
dynamically update local VLAN registration information, including the active
members and the port through which each member can be reached.
Configure the leaveall timer in system view.
Set GARP leaveall timer garp timer leaveall timer_value
Restore the default GARP
leaveall timer settings.
undo garp timer leaveall
Table 57 Display and Debug GARP
Operation Command
Display GARP statistics
information
display garp statistics [ interface
interface-list ]
Display GARP timer display garp timer [ interface
interface-list ]
Reset GARP statistics
information
reset garp statistics [ interface
interface-list ]
Enable GARP event debugging debugging garp event
Disable GARP event
debugging
undo debugging garp event
Table 56 Setting the GARP Timers (continued)
Operation Command