3Com 10014298 Switch User Manual


 
Maintaining and Debugging the System 257
Perform this command in user view.
By default, daylight saving time is not set.
Displaying System
Information and State
The following display commands are used for displaying the system state and the
statistics information. For the display commands related to each protocol and
different ports, refer to the appropriate chapters.
Perform the following operations in all views.
Debugging the System Tasks for debugging the system are described in the following sections:
Enabling and Disabling Terminal Debugging
Displaying Diagnostic Information
Enabling and Disabling Terminal Debugging
The Switch 7750 provides various ways for debugging most of the supported
protocols and functions.
The following switches control the outputs of debugging information:
The protocol debugging switch controls debugging output of a protocol.
The terminal debugging switch controls debugging output on a specified user
screen.
Figure 61 illustrates the relationship between two switches.
Table 285 Setting Daylight Saving Time
Operation Command
Set the name and range of daylight saving
time
clock summer-time zone_name {
one-off | repeating } start-time
start-date end-time end-date
offset-time
Remove the setting of the summer time undo clock summer-time
Table 286 The Display Commands of the System
Operation Command
Display the system clock display clock
Display the system version display version
Display the terminal user display users [ all ]
Display the state of the debugging display debugging [ interface {
interface-name | interface-type
interface-number } ] [
module-name ]