Anritsu Series MS278XB Network Router User Manual


 
Front Panel Menus Menu Archive
MS278XB OM 4-15
Modulation
Measurements
When in the WCDMA measurement mode with the QPSK or Composite graph type
selected, the following marker selections are available (Refer to the WCDMA Graph
Type Dialog on page 4-48 for information on setting graph types):
Active Marker: To select the active marker, press on the Active Marker field and select a
marker from the fly-out menu.
To turn the active marker on or off, press the Off/On button.
Delta Markers are not available.
Marker n(Chips): Set the active marker’s Chips by pressing in the Marker n(Chips)
parameter field (where n is the active marker’s number) and entering a value using the
numeric keys. When a new value is entered, the terminator fly-out will appear with Enter
or Cancel. The rotary knob or Up/down arrow keys may also be used to increment the
marker value.
The marker’s value is displayed in the field below Marker n(Chips) and on the graticule
display.
All Markers Off: Press the All Markers Off button to deactivate all of the markers.
Modulation
Measurements
When in the WCDMA measurement mode with the Transmit Power Control graph type
selected, the following marker selections are available (Refer to the WCDMA Graph
Type Dialog on page 4-48 for information on setting graph types):
Measured Slot: The measured slot is fixed in this mode.
On/Off and Delta Markers are not available in this mode.
Slot#: Set the Slot# for the zoom display by pressing in the Slot# parameter field and
entering a value using the numeric keys. When a new value is entered, the terminator
fly-out will appear with Enter or Cancel. The rotary knob or Up/down arrow keys may
also be used to increment the marker value. This sets the slot# used for the Zoom
displays of the Transmit Power Control.
The marker’s value is displayed in the field below Slot# and on the graticule display.
All Markers Off: Disabled in this mode.
Table 4-9. Marker Select Menu