Anritsu Series MS278XB Network Router User Manual


 
Configuration Preparation for Use
2-8 MS278XB OM
Security Settings
The following security related settings are configured in the instrument:
Internet Explorer Security Settings set to High
Firewall set to On
Encryption on File System set to Off
Passwords are Enabled on all User Accounts
Remote Access
GPIB
The default GPIB properties that are set in the factory are:
GPIB Address 1
Mode Talker/Listener
TCP/IP
All default TCP/IP settings are used.
Remote Desktop
Refer to the Remote Desktop section in Chapter 7.
Computer Name
The computer name is set to SNXXXXXX (where XXXXXX is the Anritsu serial number for the
instrument).
Third Party Software
The following third party software is loaded onto the instrument’s hard drive:
Adobe Acrobat Reader
MATLAB (A special demo version is copied onto the hard disk and requires installation.)
Hard Disk Configuration
One Primary Partition—This is the default booting partition.
One Recovery Partition—This contains a backup of the main partition that can be used to restore the
main partition if the main partition becomes corrupted. This is set up to be as small as possible (about
5% extra space is allocated in addition to the space consumed by the Recovery utility).
Note: You can access the National Instruments GPIB Configuration dialog box directly from the System Menu in
the instrument software for any changes to the GPIB settings. See “GPIB Setup” on page 2-13.
Note: You can access the Windows XP TCP/IP dialog box directly from the System menu in the instrument
software for any changes to the TCP/IP settings. See “LAN Setup” on page 2-18.