Filter
Top Products
Safety-2 MS278XB OM
For Safety
Warning: Always refer to the operation manual when working near
locations at which the alert mark, shown on the left, is
attached. If the operation, etc., is performed without heeding
the advice in the operation manual, there is a risk of
personal injury. In addition, the equipment performance may
be reduced.
Moreover, this alert mark is sometimes used with other
marks and descriptions indicating other dangers.
Warning: When supplying power to this equipment, connect the
accessory 3-pin power cord to a 3-pin grounded power
outlet. If a grounded 3-pin outlet is not available, use a
conversion adapter and ground the green wire, or connect
the frame ground on the rear panel of the equipment to
ground. If power is supplied without grounding the
equipment, there is a risk of receiving a severe or fatal
electric shock.
Warning: This equipment can not be repaired by the operator. D
o not
attempt to remove the equipment covers or to disassemble
internal components. Only qualified service technicians with
a knowledge of electrical fire and shock hazards should
service this equipment. There are high-voltage parts in this
equipment presenting a risk of severe injury or fatal electric
shock to untrained personnel. In addition, there is a risk of
damage to precision components.
Warning: Use two or more people to lift and move this equipment, or
use an equipment cart. There is a risk of back injury if this
equipment is lifted by one person.
Caution: Electrostatic Discharge (ESD) can damage the highly
sensitive circuits in the instrument. ESD is most likely to
occur as test devices are being connected to, or
disconnected from, the instrument’s front and rear panel
ports and connectors. You can protect the instrument and
test devices by wearing a static-discharge wristband.
Alternatively, you can ground yourself to discharge any static
charge by touching the outer chassis of the grounded
instrument before touching the instrument’s front and rear
panel ports and connectors. Avoid touching the test port
center conductors unless you are properly grounded and
have eliminated the possibility of static discharge.
Repair of damage that is found to be caused by electrostatic
discharge is not covered under warranty.