Anritsu Series MS278XB Network Router User Manual


 
Preparation for Use Remote Interface Setup
MS278XB OM 2-15
4. In the GPIB Configuration dialog, change the Primary GPIB Address to the desired value.
Make similar changes on the Remote PC side by selecting the System Controller choice and changing the GPIB
address as required.
When Signature is selected as the system controller, the message “System Controller” is displayed in
Signature’s status bar.
Figure 2-14. National Instruments GPIB Configuration Dialog
Note: Signature cannot be remotely controlled through GPIB by another remote PC when it is selected as the
system controller.