Filter
Top Products
58-11
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 58 Configuring QoS
Monitoring QoS
c. After you identify the traffic (see the “Adding a Service Policy Rule for Through Traffic” section on
page 36-8), click Next.
d. Click Enable priority for this flow.
e. Click Finish.
You return to the QoS tab.
Step 5 Click Finish. The service policy rule is added to the rule table.
Step 6 Click Apply to send the configuration to the device.
Monitoring QoS
To monitor QoS in ASDM, you can enter commands at the Command Line Interface tool. This section
includes the following topics:
• Viewing QoS Police Statistics, page 58-11
• Viewing QoS Standard Priority Statistics, page 58-12
• Viewing QoS Shaping Statistics, page 58-12
• Viewing QoS Standard Priority Queue Statistics, page 58-13
Viewing QoS Police Statistics
To view the QoS statistics for traffic policing, use the show service-policy command with the police
keyword:
hostname# show service-policy police
The following is sample output for the show service-policy police command:
hostname# show service-policy police
Global policy:
Service-policy: global_fw_policy
Interface outside:
Service-policy: qos
Class-map: browse
police Interface outside:
cir 56000 bps, bc 10500 bytes
conformed 10065 packets, 12621510 bytes; actions: transmit
exceeded 499 packets, 625146 bytes; actions: drop
conformed 5600 bps, exceed 5016 bps
Class-map: cmap2
police Interface outside:
cir 200000 bps, bc 37500 bytes
conformed 17179 packets, 20614800 bytes; actions: transmit
exceeded 617 packets, 770718 bytes; actions: drop
conformed 198785 bps, exceed 2303 bps