Filter
Top Products
63-13
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 63 Configuring the ASA CX Module
Monitoring the ASA CX Module
Step 10 Repeat this procedure to configure additional traffic flows as desired.
Monitoring the ASA CX Module
Use Tools > Command Line Interface to use monitoring commands.
• Showing Module Status, page 63-13
• Showing Module Statistics, page 63-13
• Monitoring Module Connections, page 63-14
• Capturing Module Traffic, page 63-17
• Problems with the Authentication Proxy, page 63-19
Note For ASA CX-related syslog messages, see the syslog message guide. ASA CX syslog messages start
with message number 429001.
Showing Module Status
See the “ASA CX Status Tab” section on page 3-26.
Showing Module Statistics
To show module statistics, enter the following command:
Examples
The following is sample output from the show service-policy command showing the ASA CX policy
and the current statistics as well as the module status when the authentication proxy is disabled:
hostname# show service-policy cxsc
Global policy:
Service-policy: global_policy
Class-map: bypass
CXSC: card status Up, mode fail-open, auth-proxy disabled
packet input 2626422041, packet output 2626877967, drop 0, reset-drop 0, proxied 0
The following is sample output from the show service-policy command showing the ASA CX policy
and the current statistics as well as the module status when the authentication proxy is enabled; in this
case, the proxied counters also increment:
hostname# show service-policy cxsc
Global policy:
Service-policy: pmap
Class-map: class-default
Command Purpose
show service-policy cxsc
Displays the ASA CX statistics and status per service policy.