Filter
Top Products
13-10
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 13 Starting Interface Configuration (ASA 5505)
Starting ASA 5505 Interface Configuration
The Auto setting is the default. If you set the speed to anything other than Auto on PoE ports Ethernet
0/6 or 0/7, then Cisco IP phones and Cisco wireless access points that do not support IEEE 802.3af will
not be detected and supplied with power.
Step 10 Click OK.
What to Do Next
• If you want to configure a switch port as a trunk port, see the “Configuring and Enabling Switch
Ports as Trunk Ports” section on page 13-10.
• To complete the interface configuration, see Chapter 14, “Completing Interface Configuration
(Routed Mode),” or Chapter 15, “Completing Interface Configuration (Transparent Mode, 8.4 and
Later).”
Configuring and Enabling Switch Ports as Trunk Ports
This procedure describes how to create a trunk port that can carry multiple VLANs using 802.1Q
tagging. Trunk mode is available only with the Security Plus license.
To create an access port, where an interface is assigned to only one VLAN, see the “Configuring and
Enabling Switch Ports as Access Ports” section on page 13-8.
Guidelines
This switch port cannot pass traffic until you assign at least one VLAN to it, native or non-native.
Detailed Steps
Step 1 Choose the Configuration > Device Setup > Interfaces pane.
Step 2 Click the Switch Ports tab.
Step 3 Click the switch port you want to edit.
The Edit Switch Port dialog box appears.