Filter
Top Products
14-7
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 14 Completing Interface Configuration (Routed Mode)
Completing Interface Configuration in Routed Mode
• If you are using failover, do not use this procedure to name interfaces that you are reserving for
failover and Stateful Failover communications. See the “Configuring Active/Standby Failover”
section on page 66-7 or the “Configuring Active/Active Failover” section on page 67-8 to configure
the failover and state links.
Restrictions
• PPPoE is not supported in multiple context mode.
Prerequisites
• Set up your interfaces depending on your model:
–
ASA 5510 and higher—Chapter 12, “Starting Interface Configuration
(ASA 5510 and Higher).”
–
ASA 5505—Chapter 13, “Starting Interface Configuration (ASA 5505).”
• In multiple context mode, you can only configure context interfaces that you already assigned to the
context in the system configuration according to the “Configuring Multiple Contexts” section on
page 11-14.
• In multiple context mode, complete this procedure in the context execution space. To change from
the system to a context configuration, in the Configuration > Device List pane, double-click the
context name under the active device IP address.
Detailed Steps
Step 1 Choose the Configuration > Device Setup > Interfaces pane.
For the ASA 5505, the Interfaces tab shows by default.
Step 2 Choose the interface row, and click Edit.
The Edit Interface dialog box appears with the General tab selected.
Step 3 In the Interface Name field, enter a name up to 48 characters in length.