Filter
Top Products
Contents
xiv
Cisco ASA 5500 Series Configuration Guide using ASDM
Starting Interface Configuration (ASA 5510 and Higher) 12-12
Task Flow for Starting Interface Configuration 12-12
Converting In-Use Interfaces to a Redundant or EtherChannel Interface 12-13
Enabling the Physical Interface and Configuring Ethernet Parameters 12-23
Configuring a Redundant Interface 12-26
Configuring a Redundant Interface 12-26
Changing the Active Interface 12-29
Configuring an EtherChannel 12-29
Adding Interfaces to the EtherChannel 12-30
Customizing the EtherChannel 12-32
Configuring VLAN Subinterfaces and 802.1Q Trunking 12-35
Enabling Jumbo Frame Support (Supported Models) 12-38
Monitoring Interfaces 12-38
ARP Table 12-39
MAC Address Table 12-39
Interface Graphs 12-39
Graph/Table 12-41
Where to Go Next 12-42
Feature History for ASA 5510 and Higher Interfaces 12-42
CHAPTER
13 Starting Interface Configuration (ASA 5505) 13-1
Information About ASA 5505 Interfaces 13-1
Understanding ASA 5505 Ports and Interfaces 13-2
Maximum Active VLAN Interfaces for Your License 13-2
VLAN MAC Addresses 13-4
Power over Ethernet 13-4
Monitoring Traffic Using SPAN 13-4
Auto-MDI/MDIX Feature 13-4
Licensing Requirements for ASA 5505 Interfaces 13-4
Guidelines and Limitations 13-5
Default Settings 13-5
Starting ASA 5505 Interface Configuration 13-6
Task Flow for Starting Interface Configuration 13-6
Configuring VLAN Interfaces 13-6
Configuring and Enabling Switch Ports as Access Ports 13-8
Configuring and Enabling Switch Ports as Trunk Ports 13-10
Monitoring Interfaces 13-12
ARP Table 13-12
MAC Address Table 13-12