Filter
Top Products
76-18
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 76 Configuring Logging
Configuring Logging
Step 5 To continue, see the “Adding or Editing Syslog Server Settings” section on page 76-18.
Adding or Editing Syslog Server Settings
To add or edit syslog server settings, perform the following steps:
Step 1 Choose the interface used to communicate with the syslog server from the drop-down list.
Step 2 Enter the IP address that is used to communicate with the syslog server.
Step 3 Choose the protocol (either TCP or UDP) that is used by the syslog server to communicate with the ASA.
Step 4 Enter the port number used by the syslog server to communicate with the ASA.
Step 5 Check the Log messages in Cisco EMBLEM format (UDP only) check box to specify whether to log
messages in Cisco EMBLEM format (available only if UDP is selected as the protocol).
Step 6 Check the Enable secure logging using SSL/TLS (TCP only) check box to specify that the connection
to the syslog server is secure through the use of SSL/TLS over TCP, and that the syslog message content
is encrypted.
Step 7 Click OK to complete the configuration.
Generating Syslog Messages in EMBLEM Format to Other Output Destinations
To generate syslog messages in EMBLEM format to other output destinations, enter the following
command:
Path Purpose
Configuration > Device Management > Logging >
Logging Setup
Sends syslog messages in EMBLEM format to output
destinations other than a syslog server, such as Telnet or SSH
sessions.