Cisco Systems ASA 5580 Network Router User Manual


  Open as PDF
of 2086
 
25-7
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 25 Configuring Static and Default Routes
Configuring Static and Default Routes
You can define a separate default route for tunneled traffic along with the standard default route. When
you create a default route with the tunneled option, all traffic from a tunnel terminating on the ASA that
cannot be routed using learned or static routes is sent to this route. For traffic emerging from a tunnel,
this route overrides any other configured or learned default routes.
Limitations on Configuring a Default Static Route
The following restrictions apply to default routes with the tunneled option:
Do not enable unicast RPF (ip verify reverse-path command) on the egress interface of a tunneled
route, because this setting causes the session to fail.
Do not enable TCP intercept on the egress interface of the tunneled route, because this setting causes
the session to fail.
Do not use the VoIP inspection engines (CTIQBE, H.323, GTP, MGCP, RTSP, SIP, SKINNY), the
DNS inspect engine, or the DCE RPC inspection engine with tunneled routes, because these
inspection engines ignore the tunneled route.
You cannot define more than one default route with the tunneled option.
ECMP for tunneled traffic is not supported.
To add or edit a tunneled default static route in ASDM, perform the following steps:
Step 1 On the main ASDM window, choose Configuration > Device Setup > Routing > Static Routes.
Step 2 Click Add or Edit.
Step 3 In the Options area, choose Tunneled.
Step 4 Click OK.
Configuring IPv6 Default and Static Routes
The ASA automatically routes IPv6 traffic between directly connected hosts if the interfaces to which
the hosts are attached are enabled for IPv6 and the IPv6 ACLs allow the traffic.
To add or edit a default static route in ASDM, perform the following steps:
Step 1 In the main ASDM window, choose Configuration > Device Setup > Routing > Static Routes.
Step 2 Click the IPv6 only radio button.
Step 3 Click Add or Edit.
Step 4 Click OK.