Filter
Top Products
Setting Up Your PowerVault NX3500 Solution 57
Controller MAC addresses:
These are used to establish communication
with the PowerVault NX3500 controllers and perform initial configuration.
This can be found on the System Identification slide out tab located
underneath the front bezel of the controller. The back of the tab lists the
“Embedded NIC 1 MAC address”. The connect button starts the co-click.
6
Click
Connect
to check if NAS controllers are connected and click
Next
.
NOTE: The slide out tab has two MAC addresses. Ensure that you enter the
embedded NIC Address and not the iDRAC address.
7
Enter the name used to identify the NAS cluster within the web
administration interface.
8
Click
Next
.
The cluster name should be only alphanumeric characters with no spaces
or special characters other than dashes.
The
Primary Network Configuration
window is displayed.
9
Type in the required parameters and click
Next
.