Filter
Top Products
Adding or replacing a CD or DVD drive
www.emachines.com
151
4 Disconnect the power, data, and sound (if attached) cables from the back
of the drive.
5 Slide the drive out of the case toward the front.
6 Slide the new drive into the drive bay from the front of the case.
7 Connect the power, data, and sound cables (if necessary) to the back of
the drive.
8 Use the two screws you removed previously to secure the drive to the drive
bay.
9 Replace the front bezel by following the instructions in “Replacing the
front bezel” on page 147.
10 Replace the side panel by following the instructions in “Replacing the side
panel” on page 147.