Filter
Top Products
Adding or replacing a hard drive
www.emachines.com
153
5 Slide the card reader out of the case.
6 Slide the new card reader into the bay from the front of the case.
7 Connect the new card reader’s USB cable to the system board.
8 Use the screw you removed previously to secure the card reader to the bay.
9 Replace the front bezel by following the instructions in “Replacing the
front bezel” on page 147.
10 Replace the side panel by following the instructions in “Replacing the side
panel” on page 147.
Adding or replacing a hard drive
Tips & Tricks
You need a Phillips screwdriver to add or
replace a hard drive.
To add or replace a hard drive:
1 Remove the side panel by following the instructions in “Removing the side
panel” on page 144.
2 If you are adding a new drive, go to Step 4. If you are replacing an existing
drive, go to the next step.
3 Disconnect the power and data cables from the back of the hard drive.