Filter
Top Products
Adding or replacing an expansion card
www.emachines.com
161
11 Insert the front bezel’s cables through the hole in the case behind the
bezel, then snap the bezel back into place.
12 Reconnect the front bezel’s power and LED cables to the appropriate
connectors on the system board.
13 Replace the side panel by following the instructions in “Replacing the side
panel” on page 147.
Adding or replacing an expansion card
To add or replace an expansion card:
1 Remove the side panel by following the instructions in “Removing the side
panel” on page 144.
2 If you are adding a new expansion card, go to the next step. If you are
replacing an expansion card, go to Step 4.
3 Remove the screw that secures the expansion card slot cover to the case,
then go to Step 7.
4 Disconnect any external cables that are attached to the expansion card
you are removing.
5 Remove the screw that secures the expansion card to the case.
6 Remove the PCI expansion card and place it in a static-free bag for storage.
You can gently rock the card end-to-end to loosen and remove the card
(do not bend the card sideways).
Screw
Screw