Filter
Top Products
Replacing the heat sink
www.emachines.com
157
Tips & Tricks
On some models, you may first need to
remove the heat sink fan.
5 Pull down on the side of the power supply nearest you, then remove the
power supply from the bay.
6 Slide the new power supply into the power supply bay until its back is flush
with the back of the case.
7 Use the four screws you removed previously to secure the new power
supply to the case.
8 Reconnect the power supply cables to the system board and to the drives.
9 Replace the side panel by following the instructions in “Replacing the side
panel” on page 147.
Replacing the heat sink
Tips & Tricks
You need a Phillips screwdriver to add or
replace the heat sink.
To replace the heat sink:
1 Remove the side panel by following the instructions in “Removing the side
panel” on page 144.
2 Place the computer case on its side.
3 Disconnect the heat sink fan’s power connector from the system board.
Connector