Filter
Top Products
Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
138
Figure 110: Attaching a Terminal to a Cable
Installing the Power Supply
To install a Summit X480 DC PSU:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
2 If necessary, remove a blank panel from the back of the Summit X480 series switch (Figure 111).
Figure 111: Removing a Blank Panel
3 Verify that the PSU is right side up (see Figure 112).
4 Carefully slide the PSU all the way into the power supply bay (see Figure 112). Push the PSU in until
the latch snaps into place.
CAUTION
Do not slam the PSU into the switch.
SH_109
SH_157