Filter
Top Products
Maintenance Procedures for Summit X650 and Summit X480 Series Switches
Summit Family Switches Hardware Installation Guide
210
Replacing a Summit X480/X650 Fan Module
The procedure for replacing a fan module is the same for either a Summit X480 series switch or a
Summit X650 series switch.
You need the following tools and equipment to replace a Summit X480/X650 series fan module:
● ESD-preventive wrist strap
● 1/2-inch flat-blade screwdriver
CAUTION
Be sure to finish the replacement procedure promptly. The switch may overheat if it is left without cooling for an
extended period.
To replace the fan module:
1 Completely loosen the captive retaining screws at the lower corners of the fan module (Figure 178).
2 Slide the fan module out of the switch and set it aside.
Figure 178: Removing a Fan Module (Summit X650 Series Switch Shown)
3 Carefully slide the replacement fan module into the switch (Figure 179).
Figure 179: Installing a Fan Module (Summit X650 Series Switch Shown)
4 Align and fully tighten the captive retaining screws.
SH_090
SH_091