Filter
Top Products
Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
164
Figure 140: Connecting the DC Power Cables (Part 2)
6 Connect the cables to the DC source voltage, using hardware appropriate to the installation site and
following local and national electrical codes.
7 Energize the DC circuit.
Leave the ESD strap permanently connected to the rack, so that the strap is always available when you
need to handle ESD-sensitive components.
Removing a Summit X650 Series Switch
This section provides procedures for removing a Summit X650 series switch from a two-post or
four-post equipment rack.
Removing the Power Supplies
Before you remove a Summit X650 series switch from the rack, remove all installed power supplies, as
described in this section.
SH_112
(+)
(–)
RTN
-48V