Filter
Top Products
Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
168
6 Remove the rack-mounting screws and detach the rear mounting brackets from the rack post
(Figure 145).
Figure 145: Removing the Rear Mounting Brackets—Two-Post Rack
Removing a Summit X650 Series Switch from a Cabinet or
Four-Post Rack
Removing the Summit X650 switch from a cabinet or rack requires two people to maneuver the switch
and disconnect the mounting hardware.
To remove the Summit X650 series switch from a cabinet or four-post rack:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate
ground point on the rack.
2 Disconnect all power cords from the back of the switch.
3 Remove all installed power supplies:
a Push the latching tab to the left as you pull the handle to disengage the power supply from its
internal connectors.
b Carefully slide the power supply out of the switch and set it aside.
4 Support the front of the switch while you remove the front rack mounting screws (Figure 146).
5 Carefully slide the switch forward out of the cabinet and off the rear mounting brackets.
SH_097