Filter
Top Products
Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
160
Figure 135: Attaching Terminals to Cables
Installing the Power Supply
CAUTION
The handle on the Summit X650 DC PSU is not designed to be used to lift or carry the Summit X650 series switch.
To install a Summit X650 DC PSU:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
2 If necessary, remove a blank panel from the back of the Summit X650 series switch (Figure 136).
Figure 136: Removing a Blank Panel
3 Verify that the PSU is right side up (see Figure 137).
4 Carefully slide the PSU all the way into the power supply bay (see Figure 137). Push the PSU in until
the latch snaps into place.
CAUTION
Do not slam the PSU into the switch.
SH_109
SH_110
Power connection wire
Ground wire
SH_106