Filter
Top Products
Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
146
To remove a mid-mounted Summit X480 series switch from a two-post rack:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate
ground point on the rack.
2 Verify that the power supplies have been removed from the switch.
3 At the front of the equipment rack, support the switch while you remove the rack-mounting screws
holding the front mounting brackets in place against the rack post (Figure 119).
Figure 119: Removing the Front Mounting Screws from a Mid-Mount Installation
4 Remove the screws holding the front mounting brackets to the sides of the switch, and set the
mounting brackets aside.
5 Support the front and back of the switch as you slide the switch back, off the rear mounting
brackets, and out of the rack (Figure 120).
Set the switch on a secure work surface.
Figure 120: Removing a Mid-Mounted Switch from a Two-Post Rack
SH_130
SH_127