Filter
Top Products
Summit Family Switches Hardware Installation Guide
151
Figure 124: Attaching a Rear Mounting Bracket—Two-Post Rack Installation
3 From the back of the equipment rack, slide the switch into place over the mounting brackets (see
Figure 125). Make sure the brackets slide between the support pegs on both sides of the switch.
Figure 125: Sliding the Switch onto the Rear Mounting Brackets
4 Push the switch forward as far as it will go, until the bracket support pegs are against the T of the
mounting bracket (Figure 126).
Securely tighten the rack mounting screws.
SH_097
SH_082